Page 1 of 1
Fingerprint workstations
Posted: Mon Jun 27, 2011 10:39 am
by kowboeega
This may not be the correct forum to address this question but here goes. Our small department has decided to purchase a latent fingerprint processing workstation and to upgrade from a fish tank to a small cyanoacrylate fuming chamber. For those who process for fingerprint do ya’ll have any suggestions on brands, types, etc. that might be helpful?
Re: Fingerprint workstations
Posted: Tue Jun 28, 2011 5:27 am
by David Grady
We have a CA-3000 from Misonix and like it a lot. It is used almost daily and yet, it's been running without incident for about five years now (I probably just jinxed it).
Dave
Re: Fingerprint workstations
Posted: Tue Jun 28, 2011 8:53 am
by areitnau
Hello,
I believe the MVC series from Foster and Freeman is a great option, expensive, but worth it. I have also used CA chambers from Air Science and Sirchie, both are good. I've had mixed results with the Misonix chambers. My 2 cents...
Re: Fingerprint workstations
Posted: Tue Jul 05, 2011 7:29 am
by walker
I've been using Misonix Downflow Workstations for over 10 years, and using the Misonix CA-6000 for 4 years. Both have performed admirably. Customer service was also excellent.