Page 1 of 1
Fuma-Dome
Posted: Wed May 07, 2008 7:12 am
by Bob McAuley
Does anyone have any infformaton on the Fuma-Dome developed by Dave Weaver Mountain State University ? or his webpage.
Bob McAuley
Posted: Wed May 07, 2008 7:24 am
by Michele
Posted: Wed May 07, 2008 8:03 am
by Bob McAuley
Thank you.
Posted: Fri May 09, 2008 10:42 am
by Graham F
So how do you control the humidity?
Posted: Fri May 09, 2008 10:47 am
by Steve Everist
Coming to CSI New York...
http://www.bdtonline.com/statenews/cnhi ... 24914.html
...unfortunately those that would use the technology don't watch the show.
Fumadome
Posted: Fri May 09, 2008 1:35 pm
by sharon cook
"...fingerprints come up in 10 to 30 seconds and you're not exposed to the fumes."
But dontcha gotta lift the dome off sooner or later?
Fuma Dome
Posted: Mon May 12, 2008 7:46 am
by rudy
Checked out the article, website, and order page for the Fuma-Dome kit.
Can someone explain to me the where and how "the releasing a vapor of, essentially, Super Glue and fluorescent dye" occurs? Is this a special super glue or an additive to the super glue?
The kit listed on his web page is only for the dome, wand, and rechargeable cyan head and another nifty carrying case.
I can see nothing on his order page regarding the fluorescent dye but read about it and saw the news clip where Weaver mentions it and it is demonstrated.
Did I miss something somewhere?
Posted: Mon May 12, 2008 12:01 pm
by sharon cook
rudy--I think this is one of those "poetic license" things that journalists are always pulling. The wand releases superglue fumes. You need a second event, dye-staining, to make the prints fluorescent. I doubt whether the dye stain is released at the same time as the superglue fumes, but I'm not a expert.
Fuma-Domw
Posted: Mon May 12, 2008 12:30 pm
by rudy
uh, I know where the super glue comes from. The news article I read states the cyanoacrylate is treated with a fluorescent dye stain.
Quote from above linked Gazette article:
"The Fuma-Dome makes fingerprints stand out by releasing a vapor of, essentially, Super Glue and fluorescent dye into the air. The dome on the device confines the vapors. When investigators place the dome over an area where there are fingerprints, the glue attaches to them and hardens to plastic."
Now, that would be a neat trick and I am surprised I haven't read of it somewhere.
Posted: Tue May 13, 2008 3:16 pm
by Charles Parker
Sharon is right---what happens when you finally got to take it off of the surface.
A bit concentrated bit of fumes I would say. Unless they have a vacuum hose hooked up to it.
Also I have seen the applicators that contain CAE and a dye that are supposed to be applied at the same time. The ones I have seen with the wand in the past did not work very well. There could be improvements since then.